Weight: Approx 7.8g
With MPU6000 (6DOF Version)
IC STM32F3CCT6 with 256K
Onboard 5V/1A BEC (Output)
Mounting: 20x20mm (M2.5)
Onboard LC Filter
Support Cleanflight & BetaFlight
Input Voltage: 2-4S Li-Po
Support Buzzer / Programing LED
Set RX3 as connection port when SBUS/DSM is used
DMS uses 3.3V
SBUS/PPM uses 5V
BLHELI_S 10A ESC
Voltage Input: 2-4S LiPo/2-4S HV LiPo
Current: 10A (15A Peak @ 5 seconds)
31*3.15mm Included Soldering Pads
Mounting: 20x20mm (M2.5 Hole)
DSHOT, OneShot Supported
MCU: SILABS EFM8BB21F16G
1 x F3 Omnibus Fight Controller
1 x 10A 4-in-1 ESC
Note: M2 Nylon Spacers are used on these boards. So you may need to get some M2 size spacers and screws.
** Warning: The default firmware shipped with the board has been tested and configured by the factory in working condition (factory flashed the board with tested firmware manually via USB). You will be responsible for damage (or any part of function not working) if you flash your own firmware. So you are recommended to use the default firmware which has been shipped with the board.
** Warning: You must be very be careful when soldering this ESC because of it’s very small size.
Full wiring diagram can be found in the download section of this website.